KOZEL profile is designed for mounting in drywall. It makes a LED fixture that creates a line of light in wall and ceiling surfaces with no aluminum parts showing. Mounting instructions
KOZEL profile can be fixed in slots made in previously fitted drywall using gypsum adhesive (GS 20 CECOL) or mounting adhesive. Before you fix the profile in drywall, you should take care to lead the power cables out. They can be led in the profile by cutting a hole in the aluminum or end cap. After the glue dries, cover aluminum collars thinly with a suitable adhesive, put the drywall mesh on, fill all and when dry, polish it in such a way that it does not affect the base edge of the profile. Finally, apply paint over the base edge of the profile. Make sure to cover the profile while performing the above work. When you have finished, remove the working cover, mount the LEDs, solder the power wires, and finally, put on a clean cover. ATTENTION: The KOZEL profile is not compatible with mounting springs (KMA groove springs).
Architectural profi les for LED fixtures – dedicated to mounting on ceilings and drywall. Their height was designed the way that they can produce a single line of light with LEDs with 15mm spacing and a frosted cover HS 22. The source of light is one or two 10 mm-wide LED strips. Surface mounting is perfomed with the use of mounting springs. During the mounting all profi les-fi xtures should have power cables led to them beforehand. Power supplies can be placed loose on the left side of the ceiling or within the walls.